Follow these easy sizing Instructions for sheet fed presses and folders running paper:

  1. Identify the MAIN blower line coming from the pump/compressor going to the feeder. Isolate the line BEFORE it separates into smaller lines going to different parts of the feeder. ALL the air going to the feeder MUST go through Ionix for it to be effective.
  2. Measure the inside diameter of that main blower hose. When selecting hose fitting, always order a unit with the hose fitting air opening equal to or larger than the ID of the blower hose. If you downsize the hose fitting you run the risk of air restriction in the blower line due to the smaller hose fitting opening.
  3. Determine the maximum sheet size that can run on the equipment (not the size of paper the customer runs on the equipment). When in doubt of sizing, always order a larger model Ionix Static Eliminator than required. Undersized Ionix units may not completely neutralize the static charges in the paper. Remember: You cannot over neutralize paper.

  4. Use the chart below:

Maximum Sheet Size Blower Hose
Inside diameter 		Ionix
Model
Up to 22" x 34"
(From 27cm x 42cm
To 55cm x 85cm) 		1/2" (15mm)
3/4" (20mm)
1" (25mm)
1 1/4” (30mm)
1 1/2" (40mm)
1 3/4" (50mm)
2" (55mm)		 200-2
200-3
200-4
200-5
400-6
400-7
400-8
From 22" x 34"
To 26" x 40"
(From 55cm x 85cm
To 65cm x 100cm) 		1/2" (15mm)
3/4" (20mm)
1" (25mm)
1 1/4” (30mm)
1 1/2" (40mm)
1 3/4" (50mm)
2" (55mm)		 300-2
300-3
300-4
300-5
400-6
400-7
400-8

Call Ionix for proper sizing of other equipment, including:

For inquiries or comments, contact us at:
Ionix Technologies Inc.
P.O. Box 3487
Boca Raton, FL 33427 		Phone:
Fax:
E-mail: 		(561) 241-1147 or (800) 246-1784
(561) 241-3116 or (800) 235-7954
info@ionixtechnologies.com
Last updated by Webmaster on September 17, 2005 at 04:33 AM.
Copyright © 1999-2003 Ionix Technologies, Inc., All rights reserved.