Instruction for installing Ionix Static Eliminator FDS
Folder Delivery System
On a Baum 714
(Models manufactured after 1991)

Before you begin, verify

  1. The inside diameter of the main blower hose coming from the pump matches the adapter size on the outside box label.
  2. The model of your folder matches the folder indicated on the outside of the box.
  3. The model of the Ionix Static Eliminator enclosed in the box matches the outside of the box.

If any parts do not match, call Ionix at 800-246-1784 for exchange parts.

Parts List:

  1. New roller guard cover with Ionix air bar
  2. Tee hose connector for air line
  3. 5’ of  ¼” hose
  4. Ionix Static Eliminator Model 200

Required tools:

  1. 5/16” Allen wrench (To unscrew hex bolts holding Baum roller cover if roller cover is still on folder.)
  2. Scissors

Installation:

Proceed with installation after you are certain the kit you have is for your folder.

  1. IF A BAUM ROLLER COVER IS ON YOUR FOLDER, use an Allen wrench to loosen the bolt on each side. The bolts are screwed into the SIDE of the folder. Loosen bolts and remove the old Baum roller folder cover. Replace with the Ionix and retighten bolts.

     

  1. IF THERE IS NO BAUM ROLLER COVER ON YOU FOLDER, simply place the Ionix FDS cover over the roller. It will drop in place and the weight of the roller cover will hold it in place.
  2. Identify the MAIN blower air line coming from the pump going to the folder feeder. Disconnect the air hose and turn the pump on verifying it is blowing air from the pump and it is not the vacuum line.
  3. Cut the blower hose and insert the Ionix Static Eliminator and reattach the blower hose.
  4. Cut the blower hose after the Ionix and insert the tee connector. A force fit will hold the hose to the Ionix and the T adapter.

  1. Select a length of ¼” hose and run it from the air bar to the connector. Connect the hose.
  2. Turn on the pump and verify air is coming out from the bottom and side of the new roller cover air bar. If so, installation in complete.

 MOST IMPORTANT!

Make sure blast air coming from pump goes through the Ionix Static Eliminator FIRST
and that the T adapter is installed AFTER the Ionix Static Eliminator.
Ionix FDS WILL NOT WORK if this is not done.

Correct installation -  Pump –> Ionix Static Eliminator –> Air splitter –> Ionix Roller Guard

Incorrect installation – Pump –> Air splitter –> Ionix Static Eliminator –> Ionix Roller Guard
If you have any installation questions or problems, call Ionix at 800-246-1784.

 Ionix Technologies
PO Box 3487
Boca Raton FL 33427-3487
Tel: 800/246-1784
www.ionixtechnologies.com
info@ionixtechnologies.com